A 3” Vibrant HD Clamp was used to attach the charge pipe to the throttle body.
We used a (82mm) Bosch Throttle Body to (3”) HD Adapter from Vibrant Performance (PN: 12471) to connect our charge pipes to the throttle body. We fabricated the charge pipes to clear the strut tower brace and allow access to the Raceonly Billet Power Steering Reservoir.
For throttle mass tuning, we installed an Omni Power 5 Bar T-MAP Sensor (PN: MAP-MUS-5BR) for the ability to measure pre-throttle pressure and temperature. The TMAP sensor is attached with a weld-on adapter fitting from ACE Performance.
With everything tacked in place and the test fitment checking out, we were ready to finish weld this charge pipe.
Mario at TSR Fabrication finish welded our charge pipe and we were good to go.
1 comment
That V-mount design and the way the air intake tucks in perfectly to the side is so cool. I still can’t wait to see the end product! Hopefully Mike can get some vids of it out of you for the YT channel.