This is our front caliper after being prepped, it is stripped down to the bare anodizing.
Our rear caliper is also stripped and ready.
Next the calipers are inspected and any areas that need more sanding are addressed. After sanding and inspection the calipers are once again carefully cleaned with degreaser and microfiber cloths.
Next the crew started to mask stuff off. We told them we did not want any overspray in the wheel wells or on the suspension. They laughed and reassured us that there would not be any and they were very experienced on working on expensive cars and picky customers.
14 comments
Should you really be getting paint on the brake caliper piston boot?
No, some OEM Brembo calipers do! It’s not going to hurt anything,
It won’t stick to the boots well, so if the boot needs to flex the paint will flake away from the boot, no problem. That’s my experience after having used high temp epoxy paint to refinish my own brembo calipers.
What do they typically charge for this service?
(I also find it odd painting over the caliper piston boots)
$600 which is reasonable because the process is about 10 man hours.
That sounds worth it for the quality of the job.
I’m curious to know which Brembos have the pistons and boots covered in paint. (I’m genuinely curious, I’ve just never experienced it). They look amazing afterwards. Could you have had the Lexus logos put back on them if you wanted?
not all of them but I have seen it on some cars like my STI. I think it so the finish won’t be damaged assembling them, they normally paint over the bolts are everything. You can put anything on them.
I have some high-end Brembo Monoblock calipers sitting on my desk and the boots are covered in paint from the factory.
Wow, the end results are impressive. Really nice to see the care that’s taken during the prep too.
FWIW, I bought a used set of front Brembo calipers taken from a 997 911 4S and the stock seals had red paint on them.
Nice work, but no signs of safety glasses, even when using power tools.
I am wondering if it wouldn’t be easier/better to pull the calipers and hang them in the wheel wells on a stiff wire, rather than doing all of that masking.
I was curious about doing this with my Brembos but looking more towards the powder coating solution. Did you consider this as well or did you know re-painting was the way to go?
Powdercoating isn’t a very temperature tolerant coating and tends to easily discolor. West Coast Calipers tells me that the paint they use is.