Project Tundra, Leveling it out with a Hellwig Big Wig Air Lift Kit


The bracket fit like it was made for the Tundra!
Unfortunately, the air tank bracket didn't come close.   Howard didn't want to drill holes in our frame so he modified the bracket to work as a bolt on part.
Howard bent the Hellwig bracket to match his measurements.   The metal was super tough so he had to heat it with a torch to be able to get a nice bend without stressing the metal.
Howard had this corner die for the hydraulic press and it was also used to get good bends on the bracket. 
Howard then welded the part of the bracket that the tank bolts to to the frame bracket he had just fabbed up.
Next Howard drilled the tank mounting holes.

Leave a Reply

Your email address will not be published. Required fields are marked *