Project White 5.0 Liter Mustang- Getting More Easy Power with an AEM Intake!


Howard attaches the intake tube to its couplers and the airbox.
The emissions hoses are attached next.  Then the airbox is bolted down and all of the hose clamps on the couplers tightened. Finally, the mass airflow meter sensing element is installed into the intake tube.
The dryflow air filter element is installed in the aribox.
The dirty element sensor is installed into the airbox.  It has a small vacuum hose that goes to the top of the air filter element.
The airbox lid is bolted down.
The intake is now installed and ready to go off to the dyno!  The installation is nice and tidy.  Will it make power?

Leave a Reply

Your email address will not be published. Required fields are marked *