,
 |
| The Stillen kit comes with this package of adhesive promoter. This is a primer of sort to make sure that the tape sticks well. |
 |
| We wiped down our clean air dam where the tape was going to be stuck with the adhesive promoter and let it air dry. |
 |
| Next we peeled up a bit of the tape’s backing on the ends. This would allow us to move the part around a little for a good fit before really sticking the part down. This is a trick they use at the Nissan factory for installing side trim or any taped down part really. |
 |
| The part is held in place while the backing is peeled off like this. |
 |
| Once the backing was completely removed we pressed the skid plate down hard like this to stick it on good. |
 |
| Then we drilled the holes for the screws. |
