Project GD STI- Keeping Cool and Protected with 3M Crystalline Tint and Protective Film

,

The film is cut on a plotter with the patterns being stored in a database.  The Tint Factory can also do custom hand cut installs if you have an aero kit for instance.  The cut film is laid on a clean table.
Next the backing paper is peeled off and the film is sprayed with soapy water.
The film is placed on the car and sprayed with more soapy water.
A 50/50 mix of alcohol and water is sprayed in areas that need extra sticking.
 
The fluid is squeegeed out from under the film.
 
 Then the edges of the film are cut to the final fit.  This requires a steady hand so you don't scratch the paint.

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*