Project SC300 Road Racer: Part 12 – Cabin Fever

,

Oh look, more holes in the car!

A little more drilling and cutting and we are ready for the circular milspec bulkhead connector that’s going to allow the trans harness to mate from the other side.

This was just about the last step involved in getting everything ready for actually installing all of the harnesses. Check back with us in the next segment as we get everything installed and ready to go so that we can fire up Project SC300 again!

XS Power

Haltech Engine Management Systems

Racepak Smartwire

Autosport Labs

AEM Electronics

Cadonix

MilSpecWiring

H Craft Customs

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*