Project EVO X GSR- Upgrading the Fuel System with RC Engineering and Cobb Tuning


The first step was to find a place to mount the box.  Howard Watanabe of Technosquare found a place on the firewall where we could use some existing bolt holes and started to fabricate a bracket out of some scrap sheet aluminum.  Here Howard marks where to make the mounting holes.
Now Howard marks the holes for the resistor box on the bracket.
The holes get punched out.  You could do this easily at home with a drill.
A little de burring and our bracket is ready to go.
Our bracket mounted in place.
Our resistor box is in place and ready to be wired.  This looks pretty factory.

Leave a Reply

Your email address will not be published. Required fields are marked *